How to Choose and Set Up a Gold Sluice Box

Keene Super Sluice aluminum sluice box with classifier screens and legs

A gold pan will teach you the basics, but a sluice box is how you move real gravel. Keene puts it plainly: in a day of sluicing you can process several hundred pounds of gravel, far more than most people could ever hand-pan. Here's how to choose a sluice that fits the way you prospect, and how to set it up, feed it and clean it up so the gold stays in the box.

How a sluice box works

It all comes down to weight. Gold is much denser than the rock and sand around it. Pure gold has a specific gravity of 19.3, while typical waste rock is about 2.5. That's why gravity tools like the pan, the rocker and the sluice box can separate it.

In a sluice, flowing water carries gravel down the box. Lighter material stays suspended and washes out the end. Heavier material, including gold, platinum metals and black sands, drops to the bottom and gets trapped by the riffles and the matting underneath. Old-time sluices were built on site from heavy wood planks. Today's are lightweight aluminum, steel or plastic, built to carry in.

Types of sluice boxes

Pocket and mini sluices: scouting and testing

  • SE Pocket-Sized Sluice: 12 x 3 in of flexible TPR plastic with Hungarian, V-shape and square riffles and a 5.5 in wide mouth. SE pitches it for scouting new areas before you bring bigger gear.
  • Keene Super Mini Sluice: 3 x 6.5 x 33 in including the flare. Keene calls it ideal for small creeks and testing small placer deposits, and the flare comes off for backpacking.
  • Gold Hog Mini Stream Sluice: comes with matting pre-installed. Gold Hog says it works on just about any stream flow, with moderate to high flows working best, and it's handy for cleaning up concentrates in the field.

Fluid-bed sluices

  • Snake River RECON Fluid Bed Sluice: 18 in long and 2.2 lb, and it fits in a 5-gallon bucket or small backpack. The maker rates it at 4–5 buckets an hour or more depending on classifying time, and says it captures 0–200 mesh gold and resets in about 30 seconds.

Backpacking and stream sluices

Full-size hand sluices

  • Keene High Production Hand Sluice: 10 x 51 x 4.5 in, with a wider flare for more flow and extra length for capacity. The flare detaches for packing.
  • Proline Large Sluice Box, 10 x 50 in: hinged access for clean-up, ribbed matting up front for quick inspection, and expanded wire welded to the bottom of the riffles to make clean-up easier.
  • Keene Super Sluice: Keene says you can dump unclassified material through it. Its screen system of grizzly bars, punch plate and woven wire classifies material and drops the water speed underneath to at least half. It has folding legs that adjust independently and can be expanded into dredge and high banker setups. 18.5 lb.

Sluices with a pump: recirculating and backyard setups

No creek nearby? A pump-fed sluice lets you work concentrates at home or in camp.

Which sluice fits you?

If you… Look at
Hike in and want to test spots SE Pocket Sluice, Keene Super Mini, Gold Hog Mini Stream, Snake River RECON
Want a packable all-day sluice Royal 24 in Compact, Royal 50 in Backpacking, Columbia River Gold Getter
Drive close to the water and run lots of gravel Keene High Production, Proline 10 x 50, Keene Super Sluice
Want to work concentrates at home Pump-fed mini sluices or the Keene A52S conversion

See every model on our gold sluice boxes page.

Step 1: Classify your material

Keene recommends prescreening gravel through a 1/4 in classifier before it goes into the sluice, which saves time and keeps the riffles from overloading. Our 1/4 in classifier has stainless steel mesh and sits right on top of a 5-gallon bucket. There's also a 1/2 in classifier if you want a coarser first screen.

Step 2: Set up in the current

  • Find a spot where the current moves quite swiftly, and set the sluice so water fills the box almost to the top.
  • Set the feed (upper) end slightly higher than the discharge end. In its general high banker instructions, Keene gives a normal sluice box tilt of about 3/4 in per running foot, or about 3 in for a 4-foot box. That's a starting point; then adjust so only part of each riffle is visible while the box is running.
  • If the box is unstable, brace it with a few rocks. Keene notes that the first few buckets of gravel often weigh it down enough.

Step 3: Feed it slowly

Feed gravel into the upper end in carefully regulated amounts. Never dump a whole bucket at once. Keene's rule of thumb: if you can't see the top crest of each riffle at all times, you're feeding too fast. Overloaded riffles let gold wash right over the packed material and out the end.

Step 4: Read the riffles and adjust

Keene's high banker instructions describe the two ways a sluice goes wrong:

  • Not enough angle: the box "loads up" and the riffles fill with excess material.
  • Too much angle: material moves too fast and the riffles run too clean, and you lose gold.

A properly working box shows only part of each riffle while it's running. While you work, flick large waste rocks out of the riffles, because they cause the current to wash concentrates out. Shovel away tailings that build up at the discharge end.

Step 5: Clean up

When the riffles have collected black sand more than halfway down to the next riffle, it's time to clean up. Lift the sluice out of the current as level as you can and carry it to the bank. Set the riffles and screen aside without shaking off what's stuck to them. Roll up the matting and rinse it into a bucket or pan. Then check the empty trough for fine silt that worked under the mat, and rinse the riffles and screen into your concentrate bucket too. Finally, pan out the concentrates.

Matting makes a big difference in what stays in the box. Browse sluice box matting and Miners Moss, plus sluice parts and accessories.

Know the rules where you sluice

Rules depend on who owns or manages the land and water. On federal BLM land, casual use generally includes collecting mineral specimens with hand tools, hand panning, and non-motorized sluicing. You can't collect on an existing mining claim without the claimholder's permission, and some areas have extra restrictions. Rules vary, and some activities need permits, so check with the land manager and your state agencies before you set up.

FAQ

What angle should a sluice box be set at?

Keene's general high banker instructions give about 3/4 in of drop per running foot as a normal sluice box tilt, or about 3 in for a 4-foot box. Use that as a starting point, then adjust so only part of each riffle is visible while the box is running. If the riffles pack up, add angle or water; if they run too clean, reduce it.

Can I run a sluice without a creek?

Yes. A pump-fed sluice, like our mini sluices with pumps or a Keene A52S with its 12-volt conversion, can recirculate water at home or in camp.

Do I need to classify before sluicing?

Keene recommends prescreening with a 1/4 in classifier to save time and avoid overloading the riffles. The Keene Super Sluice is the exception: it's designed to take unclassified material.